Micro Motion RFT9709 Manual de Instruções descarregar pdf (Página 16)

Using ProLink

Software with Micro Motion

Transmitters

Before You Begin

continued

The ProLink

kit and system requirements

Uses of the ProLink

program

While using the ProLink program, press F1 at any time for on-line help.

Use the ProLink program to:

• Transfer transmitter configurations to and from the ProLink

transmitter database, the hard drive, diskettes, or the connected

transmitter

• Upload a configuration to a Model 268 hand-held communicator

• Poll for data from devices on a multidrop network

• Set up an error log and change log

• Send data to a printer or an ASCII file

• Configure measurement units and range limits

• Read process variables and output variables

• Configure, read, trim, and test transmitter outputs

• Store messages and information such as sensor serial number and

model, flow tube and liner materials, and flange type

• Calibrate the flowmeter

• Assign events to RFT9739 outputs

• Reset the transmitter internal totalizers

• Troubleshoot the sensor, transmitter, and cable connections

File location

ProLink files are saved to the default ProLink directory on the personal

computer, unless otherwise specified by the user. Such files include:

• Change log files

• Error log files

• Ticket definition files

• Ticket destination files

If a previous release of the ProLink program is installed:

• The new software may be installed in the same directory as the

earlier version, or in a new directory. The new program files will not

overwrite any configuration or default files that were created

previously.

• The new software will use any configuration and default files that

were created using earlier ProLink versions. However, if the new

software is installed in a directory other than the default ProLink

directory, it might be necessary to locate configuration and default

files manually when using the new program.

1.2 The ProLink

kit and

system requirements

The ProLink

kit includes the items illustrated in

Figure 1-1

. To order

replacement parts, see

Appendix A

, page 169.

To use the ProLink program, the personal computer must have:

•Intel

80386 or higher version microprocessor

• Microsoft Windows version 3.1 or higher

• Hard drive with at least 2.5 MB available for storage

• 4 MB random-access memory (RAM)

• An available 9-pin or 25-pin serial port for RS-232-C communication

ProLink software compatibility with Micro Motion transmitters and

Rosemount hand-held communicators is listed in

Table 1-1

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 213 214

Comentários a estes Manuais

Sem comentários

Micro Motion RFT9709 Manual de Instruções Página 16

Comentários a estes Manuais